installation instuction for wooden,marble sticker
1.ruler 2. clean duster cloth 3.paper knife 4. Scraper
Step 1:Measure the height and width of the surface, allow approximately 1 to 2cm extra material on each side of the film when cutting
Step 2.: Use putty to plaster formed surface and round off it with water-abrasive paper, polishing surface with gloss paint will have a better effect. Any dust, stain or unsmooth surface would affect the outcome.
Step 3. Make sure film is properly aligned with the formed surface. When the top portion is smooth and the position is correct, carefully peel the backing paper off and press the film against the formed surface.
Step 4. Use the plastic scraper and work from the center out to the edges to remove any air bubbles. Puncture remaining air bubble with fine needle. Use hair-dryer to heat slight bend or wrinkle, if any, until it becomes soft enough to be scraped away.